Product Brochure for 345 GC Hydraulic Excavator AEXQ2465-00

  • 580L Product Specification Sheet

    gear-type tandem.Heavy-duty oil cool-er. LOADER HYDRAULIC PUMP CAPACITY 28.5 gpm @ 2200 rpm @ 3000 psi 31 gpm @ 2350 rpm @ 100 psi LOADER CONTROL VALVE 2 or 3-spool sectional valve with single lever control for lift,tilt and auxiliary hydraulics.Positive hold "float"and "return-to-dig". BACKHOE HYDRAULIC PUMP CAPACITY 28.5 gpm @ 2200

    Learn More
  • John Deere 310SE hydraulic problem | Heavy Equipment Forums

    Jul 19, 2018 · The loader takes 5 minutes to raise 2 inches off the ground and the hydraulic oil from the pump to the loader control valve, back through filter and back to tank gets extremely hot. Note that the rest of the valve is not getting that hot oil, so it doesn't get hot, so the oil is going from the pump to the inlet of the valve and back to the tank.

    Learn More
  • UNDERSTANDING TRUCK-MOUNTED HYDRAULIC SYSTEMS

    In pump displacement terms, we are referring to the amount of oil flow a pump produces with each complete rotation of its input shaft. Thus, a 4 cu.in. pump will, with each shaft rotation, move 4 cu.in. of oil from its inlet 20,000 lbs. 25 sq.in. 800 PSI 2,000 PSI 20,000 lbs. 10 sq.in. Pressure is …

    Learn More
  • Caterpillar 910 Wheel Loader Service Manual

    910 Wheel Loader S/n 80U1 & up Volume 1 of 2 THIS IS A MANUAL PRODUCED BYJENSALES INC. TRADE MARKS AND TRADE NAMES CONTAINED AND USED HEREIN ARE THOSE OF OTHERS, AND ARE USED HERE IN A DESCRIPTIVE SENSE TO REFER TO THE PRODUCTS OF OTHERS. bination of the pump oil force on power piston (3) and the force on the brake pedal on valve (2)

    Learn More
  • John Deere 310G Tractor Backhoe Parts Manual

    the hydraulic pump serial number is located on the bottom face of the pump. left-handside, right-handside, front and rear of the backhoe loader are viewed by facing in the direction of the backhoe loader forward travel. left-handside, right-handside, front and rear of the backhoe components are determined when seated in the backhoe operating

    Learn More
  • Schematic, Manuals, Specifications and Diagrams for Oil

    FLOAT ASSEMBLY - with screen, oil [email protected]@A39037 float assy - After SN 9008010 this is replaced by : - 1 of A155712 screen, - 1 of A155169 bracket,- 1 of 218-1026 connector,Refer also to CE Service bulletin 35-81 (Service Manual Section 2000)

    Learn More
  • Circulating Oil Systems: What You Should Know

    Sep 13, 2012 · Posted: Thu Sep 13, 2012 4:18 pm Post subject: Re: Correct fluid for Dearborn 19-42 loader w/frt pump? I would use generic HyTrans or UTF from Wal Mart, Tractor Supply, Fleet Farm or whatever you have close by. Label will say meets or exceeds Ford 134D specs. One jug to keep on hand for topping off your loader and/or tranny/rear end. EZ

    Learn More
  • JD 410B Backhoe Loader hydraulic issue - John Deere Forum

    Apr 22, 2017 · Posted: Fri Apr 21, 2017 1:27 pm Post subject: Re: JD 410B Backhoe Loader hydraulic issue: to Buickanddeere, I bumped the starter with the electric destroker solenoid removed and the front pump discharged over 2 liters (approx 2 1/2 quarts) of fluid so I assume the pump is getting enough oil pushed to it from the transmission pump.

    Learn More
  • Wagner Hydraulic Tractor Loaders (WM1, WM2, & WM3)

    Use Wagner Special Hydraulic Oil which is blended especially for use with our hydrauli- cally operated loader and is approved by the manufacturer of the pump. Drain oil from loader after 20 to 25 hours of operation. Check and clean strainer assembly.

    Learn More
  • Pressure Washer Pump Oil - How Much Oil and Type of Oil

    4 oz. X. * These pumps do not require the oil to be changed, the oil will last the lifetime of the pump. In the unlikely event of an oil leak, remove all oil and add the correct amount. ** If unable to find, use 30W non detergent. *** This pump requires no oil, it is an oil free pump. **** If …

    Learn More
  • 302A - BACKHOE, LOADER HYDRAULIC PUMP FRONT OIL PRESSURE

    hydraulic pump front oil pressure lines [01h14] 50 steering, hydraulic system rockshaft 302a - backhoe, loader epc john deere online cf 19h3239 cap screw 28h1518 washer

    Learn More
  • Correct fluid for Dearborn 19-42 loader w/frt pump? - Ford

    Loader (equipment) - Wikipedia

    Learn More
  • Circulating Oil Systems: What You Should Know

    The oil is collected from the bearing, as suggested by the name "circulating oil system." The oil is filtered and cooled (if necessary) while passing through the lubrication system. The path the oil follows is shown in Figure 2. It begins with the oil coming into the reservoir through piping connected to …

    Learn More
  • Yesterday's Tractors - Tractor Hydraulics - The Basics

    A front-end loader will usually have a pump attached by a PTO shaft to the crankshaft pulley of the engine. After the oil is exhausted from the pump it travels through a high-pressure supply line to a spool valve. A spool valve is a fancy name for a switch that controls fluids. Oil is directed through the spool valve to the selected circuit

    Learn More
  • 302A - BACKHOE, LOADER HYDRAULIC PUMP FRONT OIL PRESSURE

    hydraulic pump front oil pressure lines [01h14] 50 steering, hydraulic system rockshaft 302a - backhoe, loader epc john deere online cf 19h3239 cap screw 28h1518 washer

    Learn More
  • Hydraulic Pump Leak - BlueDevil Products

    Hydraulic pump leaks are caused by fluid bypassing the pump shaft and leaking out. A hydraulic pump is a two-part machine with the two parts connected by a shaft. First, there is the actual fluid pump which is most often a positive displacement style pump. Then, there is a motor that drives the pump, either a gas or diesel motor or in smaller

    Learn More
  • Schematic, Manuals, Specifications and Diagrams for Oil

    Find schematics, manuals, specifications and diagrams for OIL PUMP AND OIL PAN, 4T-390 ENGINE. Find genuine OEM parts for your needs.

    Learn More
  • The Quick And Dirty Guide To Pump Coupling Types

    May 18, 2017 · Elastomeric couplings are the most common coupling used today. They're found on almost every small to mid-sized pump installed due to their quick and easy installation and their innate ability to absorb all types of shock, misalignment, and end float. There are many different manufacturers, each with their own twist in the design, but the concept is the same.

    Learn More
  • Bobcat 310 | 313 | 371 Skid Steer Loader Service Manual

    A general inspection of the following items should be made whenever the loader has had service or repair. 1. Check hydraulic fluid level, engine oil level and fuel supply. 2. Inspect for any fuel, oil or hydraulic fluid leaks. 3. Lubricate the loader. 4. Check battery condition, electrolyte level and cables. 5.

    Learn More
  • Fluid Pump (Immersive Engineering) - Official Feed The

    The Fluid Pump is a block added by Immersive Engineering.It is used together with the Fluid Pipe to move liquids at faster speeds, into tanks without input/output, and to suck up liquids. The Fluid Pump is two blocks tall. To use fluid containers without explicit input/output, the Fluid Pump can be configured to automatically pull (or push) from the fluid container.

    Learn More